Esu ECoSBoost Manual de Instruções descarregar pdf (Página 7)

8.2.2. 9A Power supply

VIn:  100V–240VAC,50/60Hz

Input current: 3.6A max.

VOut:  19VDC,stabilisiert

Output current: 9.5A max.

Plug: 4-pin power Mini-DIN plug, 1.8m

wire harness

a) Power-LED (red)

b) Output socket (low voltage)

c) Main socket

Figure 4

8.2.3. Connections

•Firstofallconnectthepowersupplycablewiththecorresponding

socket of the power supply. Then plug the cable in an appropriate

power socket.

Figure 4 shows how to the power supply can be connected to the

ECoSBoostBoost.

•ToECoSBoostBoost4A50010:thepowersupplywillbeconnec-

ted via a 2.1mm DC socket.

•ToECoSBoostBoost8A50011:thepowersupplywillbeconnec-

ted via a 4-pin Mini-DIN socket.

Neveruse Yadapters forconnecting thepower supplyto other

devices of your model railway layout besides the ECoSBoostBoost!

This could cause an inadmissible contact to ground that could lead

to the destruction of your ECoSBoostBoost!

The power supply generates a stabilised voltage that serves to po-

weryour model trainlayout. A voltageof 18V canbe too high

for some N gauge decoders or locos. Therefore, we recommend

a lower track voltage when using the ECoSBoostBoost 4A for N

gauge layouts.

8.3. Track connection

The tracks are connected via a two-way socket with a removable

plug. Please make sure that you use cables of adequate size (cross-

section) for your track power. We recommend wires of at least

0.75mm² (better: 1.5mm²) cross section. In larger layouts connect

track power every two meters to the tracks.

ECoSBoost uses an H4-bridge (full bridge) for the track power.

Therefore with ECoSBoostBoost – contrary to older Märklin® sys-

tems - there is no „Common” (Ground).

Wiring details

ECoSBoost 4A 50010

ECoSBoost 8A 50011

Figure 5



1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comentários a estes Manuais

Sem comentários

Esu ECoSBoost Manual de Instruções Página 7

Comentários a estes Manuais